Do you have a question about the ROGUE Series and is the answer not in the manual?
Questions and answers
Kenneth Treutleij
May 1, 2025
Have a Napoleon BBQ RSE525RSIB purchased a kit to convert from gas to propane, but the orifice thread look different and doesn’t fit very well, one on left is old one. Something looks wrong
1 comments:
Mr. Anderson
May 16, 2025
If the orifice thread for a gas to propane conversion kit does not fit properly on a Napoleon BBQ RSE525RSIB, verify that the regulator supplies the correct pressure and that the orifice size matches the certified gas and pressure listed for your region. Use only the regulators and orifices specified for the model. If the thread still does not fit, do not force it—contact an authorized Napoleon dealer for the correct parts.
Page 1
® Owner's Manual RB425 R365, R425 & R525 RSE425, RSE525 & RSE625 RXT365, RXT425, RXT525 & RXT625 Grills illustrated in this manual may differ from model purchased. We Want Your Feedback! Visit Napoleon.com to write a review Apply Serial Number...
Page 2
Alert adults and children about the hazard of hot surface temperatures. Supervise young children near the grill. NOTICE TO INSTALLER: Leave these instructions with the grill owner for future reference. NOTICE TO CONSUMER: Keep these instructions for future reference. Napoleon.com | Rogue® Series Grills | Welcome...
Grilling Instructions Only use the pressure regulator and hose assembly supplied with this How to use the Rear Burner & Rotisserie grill or replacement parts specifically recommended by Napoleon. The Grilling Experience Checklist WARNING! Operation How to season cast iron cooking grids Read this entire Owner’s Manual before operating this grill.
Propane Tank Ring for stable tank Easy access drip storage (propane pan for efficient models only) maintenance The grills illustrated in this Owner’s Manual may differ from the model you purchased. Featured model: ROGUE RSE625 Napoleon.com | Rogue® Series Grills | Features...
CAUTION! The hook-up and installation of the gas and hose connection must be performed by a licensed gas fitter, and leak tested before operating the grill. CAUTION! Ensure the hoses do not contact any high temperature surfaces of the grill. WARNING! Accessible parts may be very hot. Keep young children away. Napoleon.com | Rogue® Series Grills Getting Started |...
Page 6
If in doubt, check with your local gas supplier. Use a gas pressure regulator and hose supplied by Napoleon; if not included, use a regulator and hose that meet national and regional codes. The recommended length of the hose is 0.9 m.
Page 7
Napoleon’s cookbooks. WARNING! Check the hose for evidence of excessive abrasion, melting, cuts or cracks. If the hose is damaged, it must be replaced with an assembly specifically recommended by Napoleon. Napoleon.com | Rogue® Series Grills Getting Started |...
WARNING! Never use an open flame to check for gas leaks. Sparks or flames will cause a fire, explosion, damage to property, serious physical injury, or death. WARNING! Only use the pressure regulator and hose assembly supplied with the STOP grill, or one in conformity with local codes. Napoleon.com | Rogue® Series Grills | Getting Started...
WARNING! Do not adjust the cooking grids while the grill is hot, or operating. WARNING! Never grill food directly on the flame side burner. It is designed for use with pots and pans only. Napoleon.com | Rogue® Series Grills Operation |...
WARNING! Regularly clean grease out of the entire unit, including the grease tray and the sear plates, to avoid build-up and grease fires. WARNING! Do not leave food unattended on any lit burners. Napoleon.com | Rogue® Series Grills | Operation...
Page 11
WARNING! Disassemble rotisserie components when finished cooking, wash with warm soapy water, and store indoors. WARNING! Use heat resistant grilling gloves when handling the hot rotisserie components. WARNING! Disconnect rotisserie plug from the outlet when the grill is not in use. Napoleon.com | Rogue® Series Grills Operation |...
NOTE: If rust has formed on the cast iron grids, sides. remove the rust with scouring pad or brass brush and 4. Preheat appliance to 350°F - 400°F (176°C - 204°C). repeat the seasoning process. 5. Install cooking grids and cook for 30 minutes. Napoleon.com | Rogue® Series Grills | Operation...
5 minutes then Medium 15 minutes each side tender meat. Trim off excess until finished Lamb Chops Select larger wieners and slit MEDIUM to LOW 4 – 6 minutes lengthwise before grilling Hot dogs Napoleon.com | Rogue® Series Grills Grilling Guide |...
WARNING! Always wear protective gloves and safety glasses when cleaning your grill. WARNING! Accumulated grease is a fire hazard. WARNING! Cleaning should only be done when the grill is cool to avoid the possibility of burns. Napoleon.com | Rogue® Series Grills | Cleaning...
Page 15
(if applicable). • Only use Napoleon approved liners on the drip pan. Never use aluminum foil, sand or any other unapproved material. This can prevent grease from flowing properly.
Page 16
Insect Screen and Burner Ports Spiders and insects are attracted to small enclosed spaces. Napoleon has equipped the burner with an insect screen on the air shutter. This reduces the likelihood of insects building nests inside the burner, but doesn’t eliminate the problem.
• Too much air flow to the burner will cause flames to lift erratically and cause igniting difficulties. Note: Infrared burners have no air adjustment. Burner Port WE WANT TO HELP! Contact the Napoleon Customer Solutions Department for recommended replacement parts. +31 345 588655. Napoleon.com | Rogue® Series Grills Maintenance |...
WARNING! Maintenance should only be done when the grill is cool to avoid the possibility of burns. WARNING! A leak test must be performed annually and when any component of the gas train is replaced, or when the smell of gas is present. Napoleon.com | Rogue® Series Grills | Maintenance...
Preheat grill with all main burners on high for 10 to 15 minutes. Excessive grease and ash build on sear plates and in drip Clean sear plates and drip pan regularly. Do not line pan with pan. aluminum foil. Refer to "Cleaning Instructions". Napoleon.com | Rogue® Series Grills Troubleshooting |...
Page 20
Pipe must be sized according to installation code. Allow burner to cool and inspect very closely for cracks. Contact Leaking gasket surrounding the ceramic tile, or a weld your authorized Napoleon dealer to order replacement burner failure in the burner housing. assembly if any cracks are found.
Page 21
2 minutes. Reignite. Allow burner to cool and inspect very closely for cracks. Contact Leaking gasket surrounding the ceramic tile, or a weld your authorized Napoleon dealer to order replacement burner failure in the burner housing. assembly if any cracks are found.
NAPOLEON. NAPOLEON warrants that components in your new NAPOLEON product will be free from defects in material and workmanship from the date of purchase, for the following period: Aluminum castings / stainless steel base ...........
Page 24
U.S. and Canadian and/or foreign patents or patents pending. De Riemsdijk 22, 4004 LC, Tiel, The Netherlands 10-12 Home Farm, Meriden Road, Berkswell, CV7 7SL, United Kingdom 24 Napoleon Road, Barrie, Ontario, L4M 0G8, Canada PHONE: +31 345 588655 www.napoleon.com eu.info@napoleon.com N415-0608CE-GB Last Revision | A | July 19, 2021 Napoleon.com | ROGUE®...
Need help?
Do you have a question about the ROGUE Series and is the answer not in the manual?
Questions and answers
Have a Napoleon BBQ RSE525RSIB purchased a kit to convert from gas to propane, but the orifice thread look different and doesn’t fit very well, one on left is old one. Something looks wrong
If the orifice thread for a gas to propane conversion kit does not fit properly on a Napoleon BBQ RSE525RSIB, verify that the regulator supplies the correct pressure and that the orifice size matches the certified gas and pressure listed for your region. Use only the regulators and orifices specified for the model. If the thread still does not fit, do not force it—contact an authorized Napoleon dealer for the correct parts.
This answer is automatically generated