Mounting The Cd-Rom Drive - LG CRD-8360B Owner's Manual

MOUNTING THE CD-ROM DRIVE

Figure 6. Removing the Floppy Disk
Drive and the Blanking plate
Figure 7. Mounting the Drive
Pin assignment
The pin assignment of the power-in
connector is as follows:
5V DC
Power supply connector
(4-pin connection cable)
Figure 8. Connecting the Power
Supply Cable
12V DC
GND
Step 1. Turn off and unplug your com-
puter and all peripheral devices
attached to it.
Step 2. Remove the cover from your
computer.
Step 3. Remove the front panel from an
unused half-height slot.
Step 4. Slide the CD-ROM drive into the
half-height slot, and secure the
drive in place with screws and
brackets.
Note: If there is too much space
between the sides of the drive and
the drive bay, you may need to
install spacer brackets, available
at your local computer store.
Step 5. Push the power supply cable
connector firmly into the power
in connector.
E-9