Check Heating System; Preparing To Transport The Dryer - Step By Step; Reversing The Door - Step By Step - Bosch WTG865H3UC Use And Care Manual / Installation Instructions

Check heating system

Check that the drum is empty.
1.
Close the dryer door.
2.
Switch the dryer to the Cotton program and select
3.
Extra Dry dryness level.
Press the Start/Pause button.
4.
After 2-3 minutes press the Start/Pause button and
5.
open the door.
If the interior of the dryer feels warm, the dryer has
▯
been connected properly. Press the center of the
Program Selector to switch off the appliance.
If the dryer does not work, press the center of the
▯
Program Selector to switch off the appliance. Look
in the Troubleshooting section of this user manual
for hints in solving the problem.
Preparing to transport the dryer - step by
step
Press the center of the Program Selector to switch off
1.
the appliance.
Pull out power supply plug.
2.
Place any accessories in the drum.
3.
Close the door and secure with adhesive tape.
4.
Screw the height-adjustable feet of the dryer into the
5.
housing to prevent them from being damaged during
transportation.
20

Reversing the door - step by step

Tip: To reverse your dryer door side:
Use only T20 (Torx) type screw driver to remove and
▯
reinstall door screws.
Do not use any other tools to reverse the door (hinge
▯
or latch).
Press the center of the Program Selector to switch off
1.
the appliance. Remove the power plug from wall
outlet. Open the door completely.
Remove the hinge screws from the dryer side then
2.
remove the door and hinge assembly from the dryer
housing.
Place the door on a flat, smooth, secure surface such
3.
as a towel or cloth lying on the floor or table.
Remove screws from the hinge insert and then remove
4.
it from the door.