Table of Contents
Advertisement
en operation
Press and hold
▶
approx. 3 seconds.
Press
or
saved programme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
12.5 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 30
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 35
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
12.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 35
Press
.
▶
a The display shows the programme
duration or the programme end
time.
Note: If "Cooling" appears, the ap-
pliance cools the laundry.
When "Cooling" goes out, the laun-
dry has cooled down.
12.7 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Press
.
1.
The cooling process starts auto-
matically after approximately 30
seconds and cools down the laun-
dry while the drum is rotating. If
36
or
for
to call up the
you want to avoid or cancel the
cooling process, open the door.
→ "Display", Page 24
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
12.8 Cancelling the pro-
gramme
Press
.
1.
Open the door.
2.
Remove the laundry.
3.
→ "Unloading the laundry",
Page 36
12.9 Unloading the laundry
Open the door.
1.
Remove the laundry from the
2.
drum.
12.10 Switching off the appli-
ance
Press
.
▶
12.11 Filter system on the
base unit
During drying, fluff from the laundry is
collected in the base unit's filter sys-
tem. The filter system protects the ap-
pliance from fluff.
Cleaning the filter system on the
base unit
If the display shows a notification
while the appliance is in operation,
clean the base unit's filter system.
Notes
¡ You can clean the filter regularly
system even without the notifica-
tion being shown on the display.
It is not necessary to clean after
each drying cycle.
Advertisement
Table of Contents
