Advertisement
B: closed loop mode:
NOTE: when sending file dump in open loop mode, you should set
up receiving mode for the receiver, otherwise receiving is
disable
7) When the power voltage is too low ,the display show LOP, now you should
check whether the power is OK. It is normal that LOP is appeared for a
short while just after power is turned on.
20. MIDI RUN
1) If MIDI data is not received within 10 minutes, the channel and program
turned on by MIDI will be cleared.
2) When sending or receiving file dump, the device ID is 55H. All
information (include System Exclusive)is sent or received in file dump.
You can send SCENE program to storage or another unit, you can also
receive SCENE program from storage or another unit.
3) this unit sends or receives NOTE information ,relevant functions is as
follows:
NOTE NUMBER
22-69
70-93
94
95
96
97
98
99
100
101
102
TRANSMITTER
MIDI IN
MIDI OUT
VELOCITY
PROGRAM MASTER
CHANNEL DIMMER
RECEIVER
MIDI IN
MIDI OUT
FUNCTION
TURN ON/OFF PROGRAM 1-48
TURN ON/OFF CHANNEL 1-24
FULL ON
DARK
HOLD
TURN ON/OFF AUDIO CHASE
CHASE
SCENES
DOUBLE
PRESET MODE
SINGLE
PRESET MODE
STEP CHANGE
BLACK OUT
Advertisement
