Technibel MPAF90MR5I Operating Instructions Manual page 24

Air Clean Filter
How to install the air clean
filter
How to clean the air clean filter
NOTE
Cleaning the main unit and
remote control unit
Removing and remounting the
front panel
CAUTION
Washing the front panel with water
24
Care and Cleaning (continued)
The air clean filter removes dust and dirt from the air, and reduces odors and
smoke from tobacco.
This air clean filter cannot remove harmful gases or vapors nor ventilate
air in the room. You must open doors or windows frequently when you
use gas or oil heating appliances. Otherwise there is a risk of
suffocation in extreme cases.
The air clean filter needs to be
installed behind the anti-mold filter.
1. Remove the anti-mold filter.
2. Install the air clean filter in
the position shown in the
figure.
3. Remount the anti-mold filter.
• In general, the filter should be sucked to remove dust in low fan speed of a
vacuum cleaner once every three months.
• If there is heavily grime on the filter, soak the filter in lukewarm water with
neutral detergent diluted 1:500 for 1 to 2 minutes then wash it.
• Rinse the filter in clean water, then let it dry on the towel in room temperature.
• Do not bend nor give excessive force onto the air clean filter.
• If the filter surface is heavily blocked with dirt or damaged, replace it with new
one. Purchase a replacement filter at your local dealer.
• Wipe clean using a soft, dry cloth.
• To remove stubborn dirt, moisten a cloth in warm water no hotter than
40 °C, wring thoroughly, and then wipe.
• The front panel can be removed in order to wash it with water.
Refer to "How to remove the anti-mold filter" and "How to replace the anti-
mold filter" on page 23.
When using a footstool or the like, be careful not to let it tip over.
• Clean the panel gently using a soft sponge, or the like. Then wipe away any
remaining moisture.
• Neutral detergent may be used to remove stubborn dirt. Then rinse
thoroughly with water and wipe away any remaining moisture.
Air clean filter