Safety Instructions And Precau; Tions; Handling By Stop Only; Installation - Xomax XM-2RSU420 Installation Manual

Topic: Safety instructions and precautions
Safety instructions and
precautions
!

Handling by stop only

To avoid any accidents please don't
handle the unit while you driving. Please
stop and park the vehicle at safety
place and handle the unit casually.

Installation

!
Please read the following manual
carefully before you install the unit. We
recommend you to let the technician
install the unit in your vehicle.
!

Regular loudness

Please set the loudness of the unit to
the appropriate level so you were still
able to hear exterior noises especially
traffic warning signals. Furthermore the
higher loudness level can damage your
hearing organs.
!

Repair of the unit

Do not open the unit. Do not try to
repair the unit by yourself due to any
emerging technical problems. While
opening the unit by yourself exists the
danger to be electrocuted.
Do not use the unit any further since
you detect any kind of technical
problems.
Leave all the repair operations to
professional technicians.
https://www.xomax.de
Due to flawed warranty seal the
!
warranty becomes invalid.
!

Power supply

Use the unit connected only to 12 Volt
on-board power supply. The minus (-)
should be connected with the ground
(GND) (negative).
Due to the wrong configuration exists
the danger of fire. In case of doubt
please consult with professional techni-
cians.

Replacement of fuses

!
While replacing the fuse please make
sure that the new fuse has the same
properties as the old one, especially the
amperage.
!

Overheating

Do not occlude the vent holes to avoid
the heat generation and accumulation
in the unit. Otherwise exists the danger
of fire.

Regular temperature

!
Before switching on the device, make
sure that the inside temperature in
the vehicle is not below 0°C or above
+40°C.
If it's too cold or too hot inside of the
vehicle, do not turn the unit on until
the inside temperature of the cabin
descends.
3
EN
XOMAX