GE Cafe CWE23SSHDSS Owner's Manual And Installation Instructions page 31

INSTALLING THE REFRIGERATOR
CONNECTING THE REFRIGERATOR
11
TO THE HOUSE WATER LINE
A cold water supply is required for automatic ice maker
operation. If there is not a cold water supply, you will
need to provide one. See Installing the Water Line section.
NOTES:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into the
wall outlet.
• If your refrigerator does not have a water filter,
we recommend installing one if your water supply
has sand or particles that could clog the screen of
the refrigerator's water valve. Install it in the water
line near the refrigerator. If using SmartConnect
Refrigerator Tubing Kit, you will need an additional tube
(WX08X10002) to connect the filter. Do not cut plastic
tube to install filter.
• Before connecting the water line to the house, purge
the house line for at least 2 minutes.
A
If you are using copper tubing, place a compression nut
and ferrule (sleeve) onto the end of the tubing coming
from the house cold water supply.
If you are using the SmartConnect
already assembled to the tubing.
Installation Instructions
(cont.)
™
tubing, the nuts are
™
Ferrule
(sleeve)
Tubing Clamp
Bride
Abrazadera del tubo
1/4" Tubing
Tuyau de 1/4 po
Tubería de 1/4 "
31
If you are using copper tubing, insert the end of the
B
tubing into the refrigerator connection, at the back of the
refrigerator, as far as possible. While holding the tubing,
tighten the fitting.
If you are using SmartConnect
end of the tubing into the refrigerator connection, at the
back of the refrigerator, and tighten the compression nut
until it is hand tight. Then tighten one additional turn with
a wrench. Over tightening may cause leaks.
Fasten the tubing into the clamp provided to hold it in
C
position. You may need to pry open the clamp.
1/4" Compression
Nut
tubing, insert the molded
™
SmartConnect
™
Tubing
Refrigerator
Connection