Watchguard XTM 2 Series Hardware Manual page 19

Rear view
Rear view of the device.
Network interfaces
The interfaces have standard RJ45 connectors and are labeled 0, 1, 2, 3, 4, 5, 6.
Interfaces 0, 1, and 2 can operate at 10 or 100 Mpbs.
Interfaces 3, 4, and 5 can operate at 10, 100, or 1000 Mbps.
Antenna (wireless models only)
The back of the XTM 2-Series Wireless has a wireless antenna.
Power input
A 12V/2A power supply is included with your device. Connect the AC adapter to the device and to a
power source. The power supply tip is plus (+) polarity.
RESET button
To reset the device, use the procedure in "Restore Factory Default Settings" on page 10.
USB interfaces
The two USB interfaces are for connections to a modem used for WAN failover, or for connections
through the Fireware XTM Command Line Interface.
Side panels
Computer lock slot
The two side panels of the XTM 2-Series have a slot for a computer lock.
Antennas (wireless model only)
The two side panels of the XTM 2-Series Wireless have wireless antennas.
Wall mounting plate (wireless model only)
The wall mounting plate enables you to put the device in a good location to increase the range.
Hardware Guide
Hardware Specifications
5