Table of Contents
Advertisement
If you ran 400 meters, adjust displayed
distance to read 400M.
7
8
Adjusting your Offset
After you calibrate the SDM Pod an Offset number is automatically
input to the watch. The default Offset number is 1.000. You can view
your adjusted Offset number by following steps
Write down and save your Offset number. Enter the number after
you change your SDM Pod battery or the watch battery to avoid
going to a track to recalibrate.
Note: Variations in pod placement and different shoe models will
affect the accuracy of your SDM Pod.
To make small adjustments to the calibration, use the manual Offset.
For example, if the SDM is slightly under measuring distance increase
the Offset number. Follow steps
EXIT
5
2
3 SEC
3
Press button
Scroll to
several times to
WORKOUT mode
scroll to Offset
(can also be accessed
in CHRONGRAPH mode)
11
through
through
to fine tune the Offset.
4
EXAMPLES
1.000 = Factory setting
0.990 = 99% of Factory calibration
1.010 = 101% of Factory calibration
You run 400m. The SDM measurement
at the end of the run was 392m (5%under).
The Offset factor would be 1.050
(5% adjustment).
.
Advertisement
Table of Contents
