Table of Contents
Advertisement
Tools you will need
• Phillips head + driver (manual or motorized) / Ø
8 mm (0.3 inches) Drill bit / Level / Stud finder /
Drill
How to attach to masonry walls
Please follow the below direction.
1 Use a drill bit Ø 8 mm (0.3 inches) to drill a
hole for the anchor location within a depth of
80 mm (3.1 inches) to 100 mm (3.9 inches).
2 Clean the drilled hole.
3 Insert the sealed wall mounting anchor to
the hole. (When inserting the anchor, use a
hammer.)
4 Set the wall mount on the wall by aligning to
the location of the hole. And, set the angle
adjusting part to face upward.
5 Align the wall mounting screw to the hole
and tighten it. Then, fasten the screws at
torque of 45 kgf/cm (39.06 lbf/in) to 60 kgf/
cm (52.08 lbf/in).
• Check the material of the wall and the thickness
of the finishing.
• Use the Wall mount anchor for wall material of
Wall mounting
anchor
Wall mounting
screw
concrete, light concrete, strong natural stone,
soft natural stone masonry brick and hallow
block that do not crack.
Wall Material
Tools
Concrete
Wall mounting
anchor, Wall
Brick
mounting
screw, Drill bit
Natural stone
(Ø 3 / 6 / 8)
Metal Panel
Plywood
Wall mounting
screw, Drill bit
(Ø 1.8)
EPS Panel
Plasterboard
+ Plywood
• When installing on a gypsum board or medium-
density fiberboard (MDF) wall, fasten the screws
to the wooden pillars that support the wall. If
there are no wooden pillars, check the distance
from the inner wall before installing.
- 30 mm (1.1 inches) or below: Install directly on
the inner wall using a 65 mm (2.5 inches) screw.
- 30 mm (1.1 inches) or above: Install using a
separate hanger.
• When installing the wall mount, check the
positions of the wooden studs using a stud
finder. Then, fasten the screws on at least two
separate studs before proceeding.
Stud
• When installing the product on wall material
not designated, install the product so that each
location can withstand the pull out load of 70
kgf (686 N) and shear load of 100 kgf (980 N) or
above.
Wall
Thickness
70 mm
(2.7 inches)
30 mm
(1.1 inches)
Penetrate the
wall
30 mm
(1.1 inches)
Wall
Wall mount
7
Advertisement
Table of Contents
