Operating From The Remote Control - Black & Decker BPACT12 Series Instruction Manual

SET UP & USE

OPERATING FROM THE REMOTE CONTROL

The first part of the controls on the remote control are the same as those on the
control panel of the appliance.
You should therefore refer to the instructions in the chapter Operating from the
Control Panel to turn the appliance on and select the operating mode (Cool, Dry,
Fan, Heat) and the fan speed.
The following section describes the additional functions corresponding to the
controls on the bottom part of the remote control.
COOLING MODE
- Press the button to turn the appliance on.
- Press the MODE button ( ) to select COOL.
- Set the temperature using the
- To select fan speed, press the FAN SPEED button repeatedly until the required
speed is selected (HIGH / MED / LOW / AUTO FAN).
NOTE: In COOLING mode, the appliance automatically removes excess moisture
from the atmosphere.
DEHUM MODE
- Keep the windows and doors closed for an effective dehumidification.
- When used as dehumidifier only keep the air exhaust hose disconnected.
- Press the button to turn the appliance on.
- Press the MODE button to select DRY. The fan speed will always be on FAN
(Fan Speed Auto) and cannot be adjusted in DRY mode.
FAN MODE
- Press the button to turn the appliance on.
- Press the MODE button to select FAN
- To select fan speed, press the FAN SPEED button ( ) repeatedly until the
required speed is selected (HIGH / MED / LOW) and AUTO FAN SPEED can not
be selected.
button.
Page 15