Panasonic KX-TG2584S Operating Instructions Manual page 14

CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this device.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Some cordless telephones operate at frequencies that may cause interference
to nearby TVs and VCRs. To minimize or prevent such interference, the base of
the cordless telephone should not be placed near or on top of a TV or VCR. If
interference is experienced, move the cordless telephone further away from the
TV or VCR. This will often reduce or eliminate interference.
Operating near 2.4GHz electrical appliances may cause interference. Move
away from the electrical appliances and/or press the CH (channel) button.
This equipment is hearing aid compatible.
A TIA/EIA-IS-968 compliant telephone cord and modular plug is provided with
this equipment. This equipment is designed to be connected to the telephone
network or premises wiring using a compatible modular jack that is also
TIA/EIA-IS-968 compliant.
CAUTION:
To comply with FCC RF exposure requirements, the base unit should be
installed with its antenna located at 20 cm or more from persons and handset
should be carried with the specific belt-clip provided for the handset to ensure
compliance.
Other non-tested belt-clips or similar body-worn accessories may not comply,
therefore, should be avoided.
– 14 –