Table of Contents
Advertisement
15 Frequently
asked questions
No signal bar is displayed on the screen.
•
The handset is out of range. Move it closer
to the base station.
•
If the handset displays [Unregistered],
register your handset.
Tip
•
For further information, see the chapter 'Services',
section 'Register additional handsets'.
If I fail to pair (register) the additional
handsets to the base station, what do I do?
Your base memory is full. Unregister the unused
handsets and try again.
Tip
•
For further information, see the chapter 'Services',
section 'Unregister the handsets'.
My handset is in searching status, what do I
do?
•
Make sure that the base station has power
supply.
•
Register the handset to the base station.
•
Move the handset closer to the base
station.
I have chosen a wrong language which I cannot
read, what do I do?
1
Press
to go back to the standby screen.
2
Press MENU/OK to access the main menu
screen.
3
One of the following texts appears on the
screen:
Réglages > Langue
Phone setup > Language
Config. tel. > Idioma
Config. telef. > Lingua
4
Select it to access the language options.
5
Select your own language.
The handset loses connection with the base
or the sound is distorted during a call.
Check if the ECO+ mode is activated. Turn it
off to increase the handset range and enjoy the
optimal call conditions.
No dialing tone
•
Check your phone connections.
•
The handset is out of range. Move it closer
to the base station.
No docking tone
•
The handset is not placed properly on the
base station/charger.
•
The charging contacts are dirty. Disconnect
the power supply first and clean the
contacts with a damp cloth.
I cannot change the settings of my voice mail,
what do I do?
The voice mail service is managed by your
service provider but not the phone itself.
Contact your service provider to change the
settings.
The handset on the charger does not charge.
•
Make sure the batteries are inserted
correctly.
•
Make sure the handset is placed properly
on the charger. The LED at the back of the
handset flashes once when charging.
•
Make sure the docking tone setting is
turned on. When the handset is placed
correctly on the charger, you can hear a
docking tone.
•
The charging contacts are dirty. Disconnect
the power supply first and clean the
contacts with a damp cloth.
•
Batteries are defective. Purchase new ones
with the same specifications. To remove the
battery door, refer to the instruction in the
following picture.
EN
33
Advertisement
Table of Contents
