Installation And Connection; Placement Of Your Oven - Panasonic INVERTER NN-GT46KB Operating Instructions Manual

Installation and Connection

Examine Your Oven
Unpack the oven, remove all packing
material, and examine the oven for any
damage such as dents, broken door
latches or cracks in the door. If you
find any damage, notify your dealer
immediately. Do not install a damaged
oven.
Earthing Instructions
If your AC outlet is not grounded, it
is the personal responsibility of the
customer to have it replaced with a
properly grounded wall socket.

Placement of Your Oven

This oven is intended for counter-top
use only. It is not intended for built-in
use or use inside a cupboard. The
microwave oven shall not be placed in
a cabinet.
Counter-top Use:
1. Place the oven on a flat and stable
surface more than 85 cm above the
floor.
2. When this oven is installed, it
should be easy to isolate the
appliance from the electricity supply
by pulling out the plug or operating
a circuit breaker.
3. For proper operation, ensure a
sufficient air circulation for the
oven.
5 cm
8
EN
15 cm
10 cm
Open
Important!
This unit has to be properly
earthed for personal safety.
Operation Voltage
The voltage has to be the same as
specified on the label on the oven. If a
higher voltage than specified is used, it
may cause a fire or other damages.
4. Allow 5 cm at one side, the other
being open; 15 cm clear over the
top; 10 cm at the rear.
5. Do not place this oven near an
electric or gas cooker range.
6. The feet should not be removed.
7. This oven is only for household
usage. Do not use outdoors.
8. Avoid using the oven in high
humidity.
9. The power cord should not touch
the outside of the oven. Keep
the cord away from hot surfaces.
Do not let the cord hang over the
edge of a table or work top. Do not
immerse the cord, plug or oven in
water.
10. Do not block the air vents on the
sides and back of the oven. If
these openings are blocked during
operation the oven may overheat.
In this case the oven is protected
by a thermal safety device and
resumes operation only after
cooling down.