Panasonic KX-TG7621 Operating Instructions Manual page 51

2
Continue from step 3, "Turning silent
mode on/off", page 50.
Changing the handset name
Each handset can be given a
customized name ("Bob", "Kitchen",
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is "Off". If
you select "On" without entering any
handset name, "Handset 1" to
"Handset 6" is displayed.
1
MMENUN M#N M1N M0N M4N
2
Enter the desired name (max. 10
characters; see the character table,
page 35).
R If not required, go to step 3.
3
MSAVEN
4
M N/M N: Select the desired setting.
MSELECTN
5
MSELECTN MOFFN
Call block (Caller ID
subscribers only)
This feature allows the unit to reject calls
when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted ("Storing unwanted callers",
page 51).
– the unit receives a call without phone
number ("Block calls without phone
number", page 52).
When a call is received, the unit rings for
a short time while the caller is being
identified. If the phone number matches
an entry in the call block list:
– cellular calls are rejected.
– landline calls are disconnected after
the unit first sends out a busy tone to
the caller.
For assistance, please visit http://www.panasonic.com/help
Important:
R When the unit receives a call from a
number that is stored in the call block
list or a call without a recognized
phone number, the call is logged in
the caller list (page 54) with
the call is disconnected.
Storing unwanted callers
You can store up to 30 phone numbers
in the call block list by using the caller
list or by entering the numbers directly.
Important:
R We recommend storing 10 digits
(including an area code). If only 7
digits are stored, all numbers that
have the same last 7 digits will be
blocked.
nFrom the caller list:
1
M NCID
2
M N/M N: Select the entry to be
blocked.
R To edit the number,
pressMSELECTN, then
pressMEDITNrepeatedly until the
phone number is shown in the
10-digit format.
3
MSAVEN
4
M N/M N:"Call block"
MSELECTN
5
M N/M N:"Yes"
6
Edit the phone number if necessary
(24 digits max.).
7
MSAVEN MOFFN
nBy entering phone numbers:
1
MMENUN M#N M2N M1N M7N
MADDN
2
Enter the phone number (24 digits
max.).
R To erase a digit, pressMCLEARN.
3
MSAVEN MOFFN
Programming
after
MSELECTN
51