Table of Contents
Advertisement
Maintenance and Repair (continued)
維護保養方法（續）
How to keep the product from freezing
有可能結冰時
1
Turn off the tap.
關閉水龍頭。
Press the Power On/Off button to turn on the power.
2
按下 [ 電源 開 / 關 ] 打開電源。
Select the "Tub Clean" program and press Start.
3
選擇 [ 筒清洗 ] 程序，按下 [ 開始 ]。
4
Remove the water supply hose and turn it downward.
(Place a shallow container or a piece of cloth under the hose as water remained in the hose
may be drained.)
14
取下供水管使其朝下。
（在供水管下方放置一個容器或一些衣物以免殘留在供水管中的水流出）
5
After approx. 30 seconds, press Pause to stop the operation.
(Water remained in water supply hose drains out.)
大約 30 秒後按下 [ 暫停 ] 停止運轉。
（殘留在供水管中的水排出）
6
Place the drain hose to the drain outlet.
將排水管放入排水口中。
Press "Spin" button and start to run spin process, then press Pause after approx. 30 seconds.
7
(Water remained in the washing machine is drained through the drain hose.)
選擇 [ 脫水 ] 程序，大約 30 秒後按下 [ 暫停 ]。
（洗衣機中殘留的水會從排水管中排出）
8
Press the Power On/Off button to turn off the power.
按下 [ 電源 開 / 關 ] 關閉電源。
How to handle freezing 如果已經結冰時
1
Disassemble the water supply hose, and put it into the warm water as hot as 40
卸下供水管，將其放入 40
2
Pour the warm water as hot as 40
o
在槽內倒入 40
C 左右的溫水。
3
Connect the water supply hose to the tap, and check the washing machine to make
sure the water supply and drain are in normal case.
再將供水管接至水龍頭，檢查洗衣機是否正常進行供水、排水動作。
Tap shall be closed fi rst before remounting the charging hose. Select "Blanket" program, slowly open the
tap after pressing the start button. (it shall be treated the same in case of long-term idleness.)
斷水後或拆掉供水管又再次裝上時，應先關閉水龍頭，選擇『被毯』程序，在按下開始按鈕後再緩慢打開水龍頭。（長
時間停止也同樣處理）
•
If there is residue air in the water supply hose and water drainage hose, the washing machine could be damaged
by compressed air, leading to leakage or injury accident.
供水管、水管中有殘留空氣，洗衣機有可能因壓縮空氣而受損，從而造成漏水或傷害事故。
40
37
o
C 左右的溫水中。
o
C into the basket.
Warning 警告
Turn off
Water
14
supply hose
37
o
C.
1
Advertisement
Table of Contents
