Table of Contents
Advertisement
Available languages
Available languages
Securing TV to the Wall
(Except for OLW480B)
• Please use the TV close to the wall after installation.
How to fix anchors and screws
(Except for OLW480B)
Please make sure that:
• Check that the material and thickness of the wall and finishing
material comply with the installation manual. Before beginning
the mounting process, you must be sure the wall is able to support
the weight of the TV.
• Should use the enclosed anchors and screws on crack-free concrete
walls.
• Never install the product on a plasterboard or wall made of paper
or medium-density fiberboard (MDF). When it is necessary to
install the product on such wall, anchor screws must be fastened
to retaining walls (concrete) or wood Stud inside the finishing
material.
• The wall mount should be attached to a stud. This usually will not
be a problem, but depending on individual circumstances, there
may be cases when the ability to mount into a stud is not possible.
In this case, there are a variety of drywall anchors, such as toggle
bolts, which may provide a solution. If using drywall anchors,
please be sure the anchors and the wall have the ability to support
the weight of your TV. Please note that the supplied anchors may
not be the correct ones for your individual situation, so you should
check with a local professional.
• Other unspecified walls must be capable of supporting pullout
loads of over 70 kgf (686 N) and shear loads of over 100 kgf (980 N)
per fastener.
• Use an Ø 8 mm drill bit for concrete and a hammer (impact) drill or
Ø 4 mm drill bit for wood stud to drill holes.
(For installation on concrete wall)
1 Drill holes in anchor locations with a drill bit of Ø 8 mm to a
depth of 80 mm to 100 mm.
2 Clean the drilled holes.
3 Insert the enclosed anchors for fixing the wall mount into the
holes. (Use a hammer when inserting anchors.)
Wall mounting anchor
4 Push the wall mount support closely toward the wall to match
the hole locations.
5 Tighten screws for fixing the wall mount to the holes. At this
time, tighten the screws to a torque of between 45 kgf/cm to
60 kgf/cm.
Wall mounting screw
9
Advertisement
Table of Contents
