Kenwood TM-D710GE Instruction Manual page 66

SmartBeaconing Operation:
Speed
Above the HIGH
FAST RATE
SPEED
The interval is
Under HIGH SPEED
calculated using the
Over LOW SPEED
following formula:
(Only when the set
(Transmission Interval
HIGH SPEED ≧
= FAST RATE x HI
LOW SPEED)
SPEED ÷ Speed)
Below the LOW
SLOW RATE
SPEED
Transmission Interval Example:
(with LOW SPEED = 5, HIGH SPEED = 70, SLOW RATE = 30
min, FAST RATE = 120 sec)
Speed
80 120 seconds (2 minutes)
70 120 seconds (2 minutes)
50 168 seconds (2 minutes 48 seconds)
30 280 seconds (4 minutes 40 seconds)
20 420 seconds (7 minutes)
10 840 seconds (14 minutes)
5 1680 seconds (28 minutes)
0 1800 seconds (30 minutes)
Corner Pegging Operation Example:
(with TURN ANGLE = 30°, TURN SLOPE = 24)
TURN SLOPE
TURN
Speed
SLOPE
Speed (1)
60 24 (x10)
50 24 (x10)
30 24 (x10)
20 24 (x10)
10 24 (x10)
5 24 (x10)
• When the value of [Turn Threshold] exceeds 120º, it is calculated as
120º.
< SmartBeaconing™ from HamHUD Nichetronix >
Transmission Corner
Pegging
Interval
Operates
normally
Operates
normally
Will not operate
Interval
TURN
÷ ANGLE Threshold
(2) (3)=(1)+(2)
4° 30°
6° 30°
8° 30°
12° 30°
24° 30°
40° 30°
PACKET MONITOR DISPLAY
This transceiver presents Terminal Window mode to display raw
data of received APRS packets. It displays up to 155 characters
per page and holds up to 10 pages.
1 Press [KEY], [P.MON].
• To enter Terminal Window mode.
2 To access old pages, press [HOLD].
• Rotate the Tuning control or press [ ] or [ ] to change the
page.
• Press [RESUME] to quit the Hold function.
• While using the Hold function, newly received packets will not be
stored in buffer.
• When press [ALLCLR], packet monitor display is cleared.
Note:
◆
The terminal window is not available for sending a command to the TNC.
◆
The terminal window is available in APRS mode (not in Packet mode).
◆
The data in buffer is cleared when the transceiver power is turned OFF.
Turn
34°
36°
38°
42°
54°
78°
APRS-21