Warning - Sony DTP-T2000A Instruction Manual

Development tool
Table of Contents

Advertisement

WARNING

WARNING
To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.
Use the supplied AC adaptor only. If
you use other types, it may cause fire,
electrical shocks or a malfunction.
Laser specifications
TM
UMD
Wave length:
655-665 nm
Power:
max 0.28 mW
Type:
Semiconductor, continuous
DVD-ROM
Wave length:
640-660 nm (DVD)
775-805 nm (CD)
Power:
max 0.3 mW (DVD)
0.23 mW (CD)
Type:
Semiconductor, continuous
CAUTION
Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure.
The use of optical instruments with this product will
increase eye hazard. As the laser beams used in the DVD-
ROM and UMD™ drives are harmful to eyes, do not
attempt to disassemble the cabinet.
Refer servicing to qualified personnel only.
This label is located on the DVD-ROM laser protective
housing inside the enclosure.
CLASS 1 LASER PRODUCT
LASER KLASE 1
LUOKAN 1 LASER LAITE
KLASS 1 LASERAPPARAT
This appliance is classified as a CLASS 1 LASER product
under IEC60825-1: 2001. The CLASS 1 LASER product
marking is located on the side of the product.
For customers in the U.S.A.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
2
WARNING
reasonable protection against harmful interference when the
equipment is operated in a commercial enviroment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
About the lithium coin memory back-up battery
The lithium coin memory back-up battery inside this
product contains Perchlorate. The following statement is
required by the State of California, USA: Perchlorate
Material - special handling may apply, See
http://www.dtsc.ca.gov/hazardouswaste/perchlorate
For customers in the U.S.A. and
Canada
This Class A digital apparatus complies with Canadian
ICES-003.
This device complies with Part 15 of the FCC Rules and
RSS-Gen of IC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation of this device.
This equipment complies with FCC/IC radiation exposure
limits set forth for uncontrolled equipment and meets the
FCC radio frequency (RF) Exposure Guidelines in
Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment should be
installed and operated with at least 20 cm (8 in) and more
between the radiator and person's body (excluding
extremities: hands, wrists, feet and legs).
This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
Pour les utilisateurs aux États-Unis et
au Canada
Cet appareil numérique de la classe A est conforme à la
norme NMB-003 du Canada.
Cet appareil est conforme aux stipulations de l'article 15 des
règlements de la FCC et RSS-Gen des règles IC. Son
opération est sous réserve des deux conditions suivantes :
(1) cet appareil ne peut pas causer de brouillage
préjudiciable et (2) cet appareil doit accepter le brouillage
préjudiciable reçu, y compris un brouillage qui pourrait
causer son fonctionnement irrégulier.
Cet équipement est conforme aux limites d'exposition aux
radiofréquences IC établies pour un environnement non
contrôlé et se conforme aux exigences de conformité pour
l'exposition aux RF IC, dans le supplément C à OET65 et
RSS-102. Cet équipement doit être installé et opéré à au
moins 20 cm (8 po.) d'écart entre le radiateur et la personne
physique (extrémités du corps non prises en compte :
mains, poignets, pieds et jambes).
Ce transmetteur ne doit pas être utilisé conjointement ou
placé avec tout autre transmetteur ou antenne.

Advertisement

Table of Contents
loading

Table of Contents