Part Names And Usage - Sony DTP-T2000A Instruction Manual

Part names and usage

Unit front
2
7
UMD
8
DVD
9
q;
qa
qs
1 On/standby button, power
indicator
This button turns the unit on and off.
To turn on the unit
Press the on/standby button while it is in standby
mode. The power indicator flashes green as the
power turns on. The indicator then turns solid
green when the system is ready. The system
status can be determined by the color and status
of the power indicator.
Flashing green The system is preparing to
start up (flashes until the
system becomes available
after the on/standby button
is pressed)
Solid green The system is starting up
(the unit can now be used)
Flashing red During system initialization
(auto-recovery)
Solid red System initialization or
update failure (indicates the
need to initialize the
system)
Flashing orange During network initialization
Solid orange Standby mode
10
Part names and usage
3
Z
4
DRIVE SELECT
5
POWER
1
1
SYSTEM INIT
6
NETWORK INIT
CONTROLLER
GPO
0
qd
1
2
3
4
5
6
qf
7
GPI
ON OFF
0
qg
1
2
3
4
5
6
7
qh
Turning the unit off (standby mode)
• Press the on/standby button and hold it down
for three seconds. The power indicator will
flash and then turn solid orange, at which point
the power will be turned off (and the system
will enter standby mode).
• Remove the power plug from the electrical
outlet after the power indicator turns solid
orange. If the plug is removed before the
indicator turns solid orange, failure of the unit
may result.
2 Disc cover
The open button (3) is used to open the cover
TM
so that a UMD can be inserted. When closing,
press the middle of the upper edge of the disc
cover.
3 Open button
This button is used to open the disc cover (2).
4 Memory Stick Duo
indicator
Turns orange while the unit is accessing a
TM
Memory Stick Duo or Memory Stick PRO
TM
Duo that has been inserted into the unit.
5 Memory Stick Duo
This slot accepts Memory Stick Duo
Memory Stick PRO Duo
6 USB connector
For connecting USB connectors (mini-B type).
When the included controller is connected to the
USB connector, the controller's USB connector
becomes functional.
7 Drive select button
Switches between the UMD
DVD-ROM drive.
The selected drive is identified by the UMD
DVD-ROM drive indicators (8). The drive
select button (7) can be used only when the
power indicator of the controller is not lit.
8 UMD TM /DVD-ROM drive indicator
The indicator for the drive, UMD
ROM, turns orange to indicate which drive is
selected.
9 Open/close button
This button is used to open/close the DVD-ROM
drive.
TM access
TM slot
TM
or
TM
media.
TM drive and the
TM
/
TM
or DVD-