Subtrim; Trimming; Direction Of Antennas During Operation; Channel Learning - Conrad Electronic RC Logger R8 Operating Instructions Manual

11.5.4.2 Upper and lower extents
The below table summarizes to you how the extents correspond to the controls' positions:
Control Extent transmission*
2-position switch Pos. 1: Lower extent
Pos. 2: Upper extent
3-position switch Pos. 1: Lower extent
Pos. 2: None
Pos. 3: Upper extent
Stick Down/Left: Lower extent
Up/Right: Upper extent
Analog knob Turning anticlockwise from mid-position: Lower extent
Turning clockwise from mid-position: Upper extent
Mid-position: None
*If a channel is reversed, the positions are reversed as well. Refer to section '11.5.1
Reversing channels' on page 16 for details.

11.5.5 Subtrim

Adjust the servo mid-points with this function (see
Navigate and set:
Functions > OK > Subtrim > OK > UP/DOWN > OK > ... > OK (long)
Subtrim
Ch1
Ch2
Ch3
Ch4
Ch5
Ch6
18 | Transmitter
[ Fig. 10 ]).
Fig. 10
1. Press the key OK to navigate between channels (CH 1 – CH 8).
2. Press the key UP and DOWN to apply subtrim.
3. Press and hold the key OK to save the settings and exit the menu, or press the key
CANCEL to exit without saving.

11.6 Trimming

For fine trimming or trimming during flight, use the left
trim settings are displayed on the LC display. Refer to 'Fig. 3' on page 11 for more
information. Each fine trim position has a distinct sound pitch associated with it. Refer to
the following table:
Left/Down
Short sounds and lower pitch

11.7 Direction of antennas during operation

It is important that you do not directly point the »Transmitter's antenna at the »NovaX 350
during operation as doing so weakens the transmitted signal. For best signal strength
maintain an angle of 90° between »Receiver and »Transmitter antenna.

11.8 Channel learning

Channel learning is required if the »Transmitter shall be used to control the »NovaX 350.
Refer to the »NovaX 350 operating instructions for instructions on how to calibrate the
»Transmitter.

11.8.1 Auxiliary switch SWD

Channel 5 is permanently assigned to R.T.H. and switch SWD (5). Do not assign any
channels to switch SWD. Refer to the »NovaX 350 operating instructions to learn more
about R.T.H.
(17) and right (7)
Mid position Right/Up
Long sound Short sounds and higher pitch
trims. Fine