Table of Contents
Advertisement
11.4.4 Resetting a model
Navigate and set:
System > OK > Model reset > OK > UP/DOWN > OK > Yes/No > OK
You can reset a model to its default settings (factory settings):
1. Navigate to and enter "Model reset".
2. Select the model you want to reset.
3. Press the key OK.
4. Confirm or cancel your action.
5. Press the key OK to confirm your selection.
11.4.5 RX setup
The following battery (power supply) settings are extremely
important. These settings protect the model from crashing
due to insufficient power supply and the flight battery from
deep discharge.
Navigate:
System > OK > RX Setup > RX Battery > OK > UP/DOWN > OK >
... >OK (long)
It must be noted that the preset voltage values are not directly measured against the flight
battery's voltage but the voltage supplied to the »Receiver via the power board. The default
settings are in most cases sufficiently accurate to protect your model from damage. The
RX setup menu is read-only.
Low voltage:
When the voltage of the flight battery falls or is below the preset value, the battery is
considered discharged.
14 | Transmitter
Alarm voltage:
When the voltage of the battery falls or is below the preset value, you will hear an audible
alarm and the battery icon in the top tray of the display flashes.
High voltage
When battery voltage is equal to the preset value, it is considered fully charged.
11.4.6 Trainer mode
Navigate and set:
System > OK > Trainer mode > OK > UP/DOWN > ... > OK (hold)
The »Transmitter offers trainer/student collaboration, whereby the trainer (master) can
temporarily hand over control to the student (slave) and take back control when necessary.
For this to work, another »Transmitter is required with identical stick modes (Mode 1 or
Mode 2). Before you proceed, read the sections regarding trainer mode in the operating
instructions of the other transmitter.
Connect a suitable trainer cable (not supplied) to the trainer port TRAINER
back of the »Transmitter. When the trainer mode is enabled, trainer/student collaboration
is controlled by an auxiliary switch.
1. Navigate to "Trainer mode".
2. Switch "Mode" to "On" and press the key OK.
3. Select an auxiliary switch (SWD is reserved for R.T.H. and cannot be assigned) for the
trainer mode and press the key OK.
4. Press and hold the key OK to confirm the settings.
5. Flip the assigned switch to engage and disengage the mode:
» 2-position switch: Pos. 1 = Disengaged, Pos. 2 = Engaged
» 3-position switch: Pos. 1 = Disengaged, Pos. 3 = Engaged
(19)
at the
Advertisement
Table of Contents
