Home Screen; Main Menu - Conrad Electronic RC Logger R8 Operating Instructions Manual

> If the »Transmitter does not detect any user input within a preset time interval an
audible alert will sound. Refer to section '11.4.9 Alarm settings' on page 15 for more
information.
11.2.1.2 Turning off
1. Disconnect the flight battery.
2. Slide the power switch POWER down to its off position.
3. The LC display goes out.

11.2.2 Home screen

M01
s7
NovaX_01
s6
R
Int.V 1:5.05
X
Ext.V 2:0.00
L
TX.V 1:5.51
s5
s1 Transmitter battery status ('Beep' alert if < 4.2 V)
s2 Receiver battery status (power supply via power board)
s3 Data feedback
s4 Right trims
s5 Left trims
s6 Model name of selected model
s7 Model number of selected model
12 | Transmitter
TX
s1
RX
s2
s3
s4

11.2.3 Main menu

MENU
System setup
The main menu [ Fig. 5 ] is divided into two submenus: { System } and { Functions }
> With the system menu you manage up to 20 models (A model is a unique set of settings)
and set up the »Transmitter. With the functions menu you set up individual models.
> Press and hold the key OK (8)
to enter the main menu.
Study the following table to learn more about the menu keys:
Key Function
OK – Press and hold to enter the main menu
– Enter submenus
– Confirm selection or setting
OK Press and hold to confirm settings
CANCEL Exit submenu or menu;
Cancel input
UP Move up;
Make adjustments
DOWN Move down;
Make adjustments
Fig. 5
Sound pitch
Medium
High
Low
Medium
Medium