INSTALLATION
Before You Begin
Always disconnect the negative battery terminal
Important Notes
Before final installation, test the wiring connections to make sure the unit is
•
connected properly and the system works.
Consult with your nearest dealer if installation requires the drilling of holes or
•
other modifications to your vessel.
Install the unit where it does not interfere with operating the vessel and
•
cannot injure passengers.
Use the included template to cut the installation opening.
•
Commander Cover
During storage, use the included cover to prolong the life of your device by
•
protecting the wired commander from direct sunlight, moisture, dust, and
other elements.
Wired Commander Mounting
Choose a mounting area for the wired commander that is clean and flat,
•
allowing the rear gasket to fully seal to the mounting surface.
Secure the wired commander using either of the recommended mounting
•
methods detailed below.
Bracket Mount
Insert wired commander through cut-out and secure with bracket using
•
included hardware as detailed in the diagram.
Screw Mount
Secure the wired commander to the mounting surface using #6 stainless steel
•
pan head screws (not included) as detailed in the diagram.
Bracket Mount
Screw Mount
5
PA4A