Table of Contents
Advertisement
Setting the User Passcode
1.
Press and hold the MENU button for more than 3 seconds to enter the
system menu.
2.
Rotate the Encoder Knob to navigate the menu list to the "SXM SETUP
MENU" option.
3.
Press the Encoder Knob button to view "Set Lock Code".
4.
Press the Encoder Knob button to select Set Lock Code. "Enter Lock Code:
0 _ _ _" prompt message will appear.
5.
Rotate the Encoder Knob to select a digit (0 – 9) for each number position.
The default code is "0000". Press the Encoder Knob button to confirm
each digit and move to the next digit.
6.
Upon entering the last digit, the unit will prompt for confirmation of the code.
7.
Repeat the same steps to enter the code again.
Locking a Channel
1.
Press and hold the MENU button for more than 3 seconds to enter the
system menu.
2.
Rotate the Encoder Knob to navigate the menu list to the "SXM SETUP
MENU" option.
3.
Rotate the Encoder Knob to "Locked Channels...".
4.
Press the Encoder Knob button to select. "Enter Lock Code: 0 _ _ _"
prompt message will appear.
5.
Enter the Lock Code, a list of channels with open lock icons will appear.
6.
Rotate the Encoder Knob to select a channel you wish to lock
7.
Press the Encoder Knob button to lock the channel. The locked icon will
indicate the channel has been successfully locked.
Accessing a Locked Channel
1.
Tune to the desired channel using the |<< or >>| soft buttons or use the
direct access tuning method.
2.
An "Enter Lock Code: 0 _ _ _" prompt message will appear.
3.
Enter the Lock Code within 10 seconds to unlock and tune the channel.
4.
The device will remain in "unrestricted" (unlocked) mode until the next power
cycle.
Reset SiriusXM Channel Lock Code
If you forget your Parental Control lock code, use the following directions to reset
the code to the default "0000". Resetting the lock code will not affect the locked
channels list.
1.
In SiriusXM mode, tune to Channel 0.
2.
Rotate the Encoder Knob to change the volume setting to 0.
3.
Press the Power Button to turn off the unit.
4.
With the unit turned off, press and hold the Power Button until the system
version information is displayed on the screen.
5.
Press the Encoder Knob button to turn the LCD display off.
6.
Press the Power Button to turn on the unit.
7.
The lock code has now been reset to "0000".
INFO
Alternate Display Information
INFO option is available in TUNE, CAT and PSET LIST modes. Press INFO soft
button to change the display information in the following order:
NAME (Artist) > SONG (Title) > INFO (Content, if available) > CAT (Category) >
NAME (Artist).
Satellite Signal Strength
The display will indicate satellite reception strength as shown below.
Signal Strength
No Signal
Weak
Good
Excellent
16
PA4A
Strength Display
Advertisement
Table of Contents
