Table of Contents
Advertisement
802.11g Protection Enable/disable 802.11g protection, which
802.11n Protection Enable/disable 802.11n protection, which
DTIM Period
RTS Threshold
Fragment
Threshold
Multicast Rate
Tx Power
Beacon Interval
Station idle
timeout
39
increases reliability but reduces bandwidth
(clients will send Request to Send (RTS) to
access point, and access point will broadcast
Clear to Send (CTS), before a packet is sent
from client.)
increases reliability but reduces bandwidth
(clients will send Request to Send (RTS) to
access point, and access point will broadcast
Clear to Send (CTS), before a packet is sent
from client.)
Set the DTIM (delivery traffic indication
message) period value of the wireless radio.
The default value is 1.
Set the RTS threshold of the wireless radio. The
default value is 2347.
Set the fragment threshold of the wireless
radio. The default value is 2346.
Set the transfer rate for multicast packets or
use the "Auto" setting.
Set the power output of the wireless radio. You
may not require 100% output power. Setting a
lower power output can enhance security since
potentially malicious/unknown users in distant
areas will not be able to access your signal.
Set the beacon interval of the wireless radio.
The default value is 100.
Set the interval for keepalive messages from
the access point to a wireless client to verify if
the station is still alive/active.
Advertisement
Table of Contents
