Table of Contents
Advertisement
TRENDnet User's Guide
Configure Access Control Lists (ACL)
Security > ACL
Access Control configuration allows you to control different aspects of the Ethernet
traffic as it enters the switch ports and is process through the Switch. You can specify
what traffic is permitted or denied to flow through the switch by setting up specific filter
criteria at an ingress port. You can also manage the switching priority of Ethernet
packets. All of this is done by specifying policies that define the filtering and priority
behavior.
Configure Policy Settings
Security > ACL > ACL Configuration Wizard
The ACL Configuration Wizard page allows for simple configuration of ACL profiles and
rules.
1. Log into your switch management page (see
on page 7).
2. Click on Security, click on ACL, and click on ACL Configuration Wizard.
3. Review the settings. Click Apply to save the settings.
ACL Configuration Wizard
Create an ACL rule by selecting the appropriate fields.
Source- Defines the access packet origin.
o
Any- Indicates ACL action will be taken on packets from any source.
o
MAC Address – Indicates ACL action will be taken on packets from the
specified MAC address.
o
IPv4 Address- Indicates ACL action will be taken on packets from the
specified IPv4 source address.
o
IPv6 Address- Indicates ACL action will be taken on packets from the
specified IPv6 address.
Destination- Defines the access packet destination.
o
Any- Indicates ACL action will be taken on packets to any destination.
© Copyright 2017 TRENDnet. All Rights Reserved.
"Access your switch management
page"
o
MAC Address – Indicates ACL action will be taken on packets to the
specified MAC address.
o
IPv4 Address- Indicates ACL action will be taken on packets to the
specified IPv4 source address.
o
IPv6 Address- Indicates ACL action will be taken on packets to the
specified IPv6 address.
Service Type- Defines the type of service.
o
Any- Indicates the ACL action will be taken on packets of all types of
service.
o
EtherType- Specifies EtherType packet filtering.
o
ICMP All- Specifies ICMP packet filtering.
o
IGMP- Specifies IGMP packet filtering.
o
TCP All- Specifies TCP packet filtering.
o
TCP Source Port- Matches packet to corresponding TCP Source Port.
o
TCP Destination Port- Matches packet to corresponding TCP
Destination Port.
o
UDP All- Specifies UDP packet filtering.
o
UDP Source Port- Matches packet to the corresponding UDP Source
Port.
o
UDP Destination Port- Matches packet to the corresponding UDP
Destination Port.
Action- Defines the ACL action linked to the rule criteria.
o
Permit- This selection allows ingress packets that conform to the
specified ACL criteria.
o
Deny- This selection drops ingress packets that conform to the
specified ACL criteria.
o
Rate Limiting- Activates rate limiting if all ACL criteria are met.
o
Replace DSCP- Enter a number in the Replaced-DSCP field within the
range of 0 to 63. This field indicates the DSCP level of interest. This
field is not mandatory and you may elect to leave it blank.
Ports- Defines the ports to be configured.
TEG-204WS
75
Advertisement
Table of Contents
