Advertisement
TROUBLESHOOTING
PROBLEM
APPLIANCE OPERATION
Appliance does
not run.
Interior tempera-
ture is too cold.
Interior tempera-
ture is too warm.
SOUND AND NOISE
Vibrating or
rattling noise.
WATER/MOISTURE/FROST INSIDE APPLIANCE
Moisture forms on
inside walls.
LIGHT BULB IS NOT ON
Power Available
Light is not on
10
CAUSE
• Appliance is plugged
into a circuit that has a
ground fault interrupt.
• Temperature Control is
in the OFF position.
• Appliance may not be
plugged in or plug may
be loose.
• House fuse blown or
tripped circuit breaker.
• Power outage
• The temperature is set
too low.
• Temperature Control is
set too warm.
• Lid is kept open too
long or is opened
too frequently.
• Large amounts of warm
or hot food may have
been stored recently.
• Appliance has recently
been disconnected for a
period of time.
• Appliance is not level. It
rocks on the floor when
it is moved slightly.
• Floor is uneven or
weak. Appliance rocks
on floor when it is
moved slightly.
• Weather is hot and humid,
which increases internal
rate of frost build-up.
• Lid may not be
seating properly.
• Lid is kept open too
long, or is opened
too frequently.
• LED may be burned out.
• No electric current is
reaching the freezer.
CORRECTION
• Use another circuit. If you are unsure about
the outlet, have it checked by a certified
technician.
• See CONTROLS AND SETTINGS
Control section.
• Ensure plug is tightly pushed into outlet.
• Check/replace fuse with a 15-amp time
delay fuse. Reset circuit breaker.
• Check house lights. Call a qualified electrician.
• Turn control to a warmer setting.
• Turn control to a colder setting. Allow 24
hours for the temperature to stabilize.
• Warm air enters the appliance every time
the lid is opened. Open the lid less often.
• Wait until the appliance has had a chance
to reach its selected temperature.
• Appliance requires 24 hours to cool
down completely.
• Level the unit. Refer to "Leveling" in
the INSTALLATION.
• Ensure floor can adequately support appli-
ance. Level the appliance by putting wood
or metal shims under part of the appliance.
• This is normal.
• Carefully warm the leaking sections of the
door seal with a hair dryer set on "cool".
Simultaneously shape the warmed door
seal by handso that it seats correctly.
• Open the lid less often.
• Contact a qualified service dealer.
• See "Appliance does not run" in the
APPLIANCE OPERATION Section.
Advertisement
