Install The Oven; Cabinet Installation - LG LWS3063BD/00 Installation Manual

Part 4

INSTALL THE OVEN

1

CABINET INSTALLATION

The fifth step of the installation is to install the oven into the cabinet as follows:
1. Sliding the oven into the opening.
a. Loop (do not tie) a 36" (91 cm) string around the conduit before the oven is slid into place.This will keep the
conduit from falling behind the oven.
b. Lift oven into cabinet cutout using the oven opening as a grip. Carefully push against the oven front frame.
Do not push against outside edges.
c. While sliding the oven back, pull the string so that the conduit lies on the top of the oven in a natural loop.
d. When you are sure the conduit is out of the way, slide the oven 3/4 way back into the opening. Remove the
string by pulling on one end of the loop.
CAUTION
• DO NOT block the oven air exhaust
located at the bottom of the oven.
- Blocking the exhaust may cause cabinet damage
and product malfunction.
2. Securing the oven.
a. Using the mounting holes on the oven side trim as
a guide, drill pilot holes for screws provided (For
securing the double wall oven, use a minimum of
4 screws, one on each side in both the upper and
lower ovens. For securing the single wall oven, use
a minimum of 2 screws, one on each side.)
b. Secure the oven to the cabinet with screws
provided.
If the cabinet is particle board, you must use 3/4"
particle board screws. These may be purchased at
any hardware store.
3. Installing the metal bottom trim.
(For model : LWS3081ST, LWD3081ST, LWS3010ST, LWD3010ST)
a. Place the metal bottom trim centered over the pre-
drilled mounting holes on the lower base.
b. Using 3 screws provided, secure the bottom trim
to the bottom edge of the cabinet.
4. Reinstalling the oven door.
(For model :LWS3081ST, LWD3081ST, LWS3010ST, LWD3010ST)
Step. 1
Firmly grasp both
sides of the door at
the top.
Step. 2
With the door at the
same angle as the
removal position, seat
the indentation of the
hinge arm into the
bottom edge of the
hinge slot. The notch
in the hinge arm must
be fully seated into the bottom of the slot.
Hinge arm
Bottom
edge of
slot
Indentation
• Mounting screws must be used.
- Failure to do so can result in the oven falling out
of the cabinet causing serious injury.
Mounting
Hole
Locations
Mounting
Hole
Locations
Step. 3
Fully open the door. If the door will not fully open, the
indentation is not seated correctly in the bottom edge
of the slot.
Step. 4
Push the hinge locks up
against the front frame of
the oven cavity to the locked
position.
Step. 5
Close the oven door.
- 11 -
WARNING
Trim Screws
Side Trim
Metal
Lower base
bottom
trim
Metal Trim:
Correct
position
Metal Trim:
Wrong
position
Hinge arm
Hinge lock
Side
Trim