Function Instruction; Important Notes - Danby DCF100A1WDD Owner's Manual

OPERATING INSTRUCTIONS

FUNCTION INSTRUCTION

1
1. SETTING TEMPERATURE:
• Press the temperature setting key to set or adjust
the temperature.
• Temperature can be set between -14°C to -24°C
(7°F to -11°F).
• The recommended temperature setting is -18°C
(0°F).
2. SWITCHING BETWEEN °C AND °F:
• To switch between °C and °F, press the °C/°F
key and the corresponding indicator light will
illuminate.
3. SETTING FAST FREEZE:
• The Fast Freeze function allows the unit to run
at very low temperature (-24°C ~ -26°C) for 24
hours before reverting to previous settings.
• To activate the Fast Freeze function, press and
hold the Fast Freeze button for 3 seconds and
the adjacent LED indicator light will illuminate.
• To cancel the Fast Freeze function, press the Fast
Freeze button or the temperature setting button
and the adjacent LED indicator light will turn off.
2 3

IMPORTANT NOTES

• The freezer lid may be diffi cult to open
immediately after closing it. This is normal and
is due to the pressure difference between the
cold interior of the freezer and the warm air that
has just entered the freezer. The pressure will
equalize within a few minutes.
• If the lid is especially diffi cult to open, wait 5
minutes to allow the pressure to equalize and
then try again.
• The temperature inside the appliance can
vary based on ambient room temperature, the
frequency that the lid is opened and the amount
of fresh food that has recently been added to the
appliance.
• Do not overload the appliance as this can affect
performance.
• Do not freeze large quantities of fresh food at
the same time.
4