Battery Information - Acer DMZ200 Quick Manual

Table of Contents

Advertisement

Safety

Battery information

Do not use this product in a humid, wet and/or
corrosive environment. Do not put, store or leave your
product in or near a heat source, in a high temperature
location, in strong direct sunlight, in a microwave oven
or in a pressurized container, and do not expose it to
temperatures over 60° C (140° F). Failure to follow
these guidelines may cause the battery to leak acid,
become hot, explode or ignite and cause injury and/or
damage. Do not pierce, open or disassemble the
battery. If the battery leaks and you come into contact
with the leaked fluids, rinse thoroughly with water and
seek medical attention immediately. For safety
reasons, and to prolong the lifetime of the battery,
charging will not occur at low (below 0° C/32° F) or
high (over 45° C/113° F) temperatures.
The full performance of a new battery is achieved only
after two or three complete charge and discharge
cycles. The battery can be charged and discharged
hundreds of times, but it will eventually wear out.
When the talk and standby times are noticeably
shorter than normal, buy a new battery. Use only
manufacturer approved batteries, and recharge your
battery only with manufacturer approved chargers
designated for this device.
Unplug the charger from the electrical plug and the
device when not in use. Do not leave a fully charged
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Liquid z200

Table of Contents