Table of Contents
Advertisement
5Installation
Preparing for installation
I n s t a l l a t i o n
Caution!
Ensure that there are no electrical wires, gas pipes or
water pipes in the area where holes are to be drilled.
Determine where the extractor hood should be
1.
positioned and lightly mark where the lower edge of
the appliance should be on the wall. Determine
where the middle should be based on the hob.
We recommend fitting the extractor hood such
Note:
that the lower edge of the glass screen is in line with
the lower edges of the adjacent wall-hung cabinets.
Make sure that the specified safety clearances from
the hob are complied with.
Place the template against the line drawn on the wall
2.
and fasten it in place. Mark where the screws should
be inserted.
Drill 8 mm diameter holes to a depth of 80 mm for
3.
fastening the appliance, remove the template and
press in the wall plugs flush with the wall.
Fitting without a flue duct
Installation
Screw in the mounting supports for the extractor hood
until they are hand-tight, use a spirit level to level the
appliance and then screw the mounting supports in
fully.
Wall-mounting the appliance and levelling it
First remove the protective film from the back of the
1.
appliance and, following installation, remove the rest
of the film.
When mounting the appliance, ensure that it
2.
engages properly with the mounting supports at the
top and bottom. Position the appliance at a slight
angle.
If required, the appliance can be moved to the right
3.
or to the left.
Tighten the locking screws fully.
4.
Installation en
13
Advertisement
Table of Contents
