Table of Contents
Advertisement
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
points at
the equipment.
This device has been tested and found to comply with the limits for a Class B digital, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
.
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
ycling and
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
equipment
FCC RF Exposure Information (SAR):
arger you
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission of the United States.
During SAR testing, this is set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that
simulate RF exposure in usage near the body with the separation of 0 cm. Although the SAR is determined at the highest certified
power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the device is
may not
designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you
undesired
are to a wireless base station antenna, the lower the power output.
17
Advertisement
Table of Contents
