General Information; Diagnosis; Service Mode - Pioneer KEH-M1096ZT/X1B/EW Service Manual

Fm/am cassette deck

Table of Contents

7. GENERAL INFORMATION

1. Entering the mode

Input "H" to the SMODE terminal when the microcomputer resets.

(Set the RESET terminal to "L," while inputting "H" to the SMODE terminal.)

2. Terminating the mode

Set ACC (accessories) to OFF.

3. Valid keys in the mode

Keys valid for always

Keys valid for POWER ON

TAPE

TUNER

In Service mode, only the keys listed above are valid. The analog switch is switched to output audio from an

internal source.

Note : If a navigator or display is connected to the system in this state, the connected equipment does not operate

normally, even though it appears as if operating. Be sure to set ACC to OFF to terminate Service mode, then

connect the equipment.

: POWER, MODE (REMOTE CONTROL UNIT)

: EJECT (HEAD UNIT)

: MUTE, VOL UP/DOWN (REMOTE CONTROL UNIT)

: PROG, APS+/-, FF/REW (REMOTE CONTROL UNIT)

: PROG, RPT, SCAN, DOLBY (HEAD UNIT)

: UP/DOWN (REMOTE CONTROL UNIT)

KEH-M1096ZT

Table of Contents