Table of Contents
Advertisement
Q. In order to making the HomePlug Ethernet Bridge working properly, do I
have to install the HomePlug Connection Manager on every single
computer who has the HomePlug Ethernet Bridge plug into it?
A. No, the HomePlug Connection Manager is a utility to diagnose or setup
encryption for HomePlug device. Due to HomePlug Ethernet Bridge is a
fully plug & play device, no driver require to install. So technically
speaking, the HomePlug Connection Manager is not a requirement to
install on your computer. In other words, you can install the utility, setup
the encryption, and delete it from your computer, but your HomePlug
Ethernet Bridge will still working properly.
Q. How many HomePlug Ethernet Bridges that I can install into one same
Local Area Network?
A. Unlimited. But by the IP restriction, you might be able install up to 253
units in one same Local Area Network.
Q. Can I connect my HomePlug device to an extension cord or an UPS?
A. Yes, HomePlug devices can be plugged onto extension cords, but please
note that this will reduce the powerline signal strength of the connection.
Sometime it may even reduce it to zero! Please use a wall outlet if it's
possible. HomePlug devices do not work with UPS at this time.
Q. Can I connect my HomePlug Ethernet Bridge to my Ethernet enabled
PS2/Xbox/other device?
A. Yes. Because HomePlug Ethernet Bridge is a fully plug N play device, no
driver installation require.
Q. Can I use other HomePlug brands with this one?
A. Yes. However, it's not recommended to mix HomePlug units with other
brands as the internal board may be slightly different. As long as all
HomePlug devices under the HomePlug 1.0 Specs, then they should be
OK.
Q. Will anything happen if lighting strikes my house?
A. All our HomePlug devices have lighting protection build-in. It will only
cause the internal board of the HomePlug device to short circuit. However,
it will not damage your computer or anything plug in with it.
32
Advertisement
Table of Contents
