Table of Contents
Advertisement
DHCP Client Range
* Please click on the Apply Changes button or the Reset button at the bottom to save/reset the configurations.
Active DHCP Client List
This is the window that pops up after clicking the
of IP address, MAC address and expire time of the DHCP clients that have connected with this
device.
3.5.2 WAN Interface Setup
This page allows users to configure those parameters for connecting to Internet. You may
select the Internet connection type from the drop list besides "WAN Access Type" and configure
the parameters for each mode. There are three modes for your selection: Static, DHCP and
PPPoE.
DHCP stands for Dynamic Host Configuration Protocol. It is a
protocol for assigning dynamic IP addresses "automatically".
This field asks you to specify the DHCP Client IP address range
(default 100~200). You can also click the "Show Client" button to list
those connected DHCP clients.
Note: in Router/Client mode, DHCP Server default setting is enabled,
however in AP mode, DHCP Server default setting is disabled.
(Router mode and Client mode)
28
Wireless 11n 1T1R Router
button. It shows the information
Advertisement
Table of Contents
