Table of Contents
Advertisement
Installing the Switch
1
Align the two rear rack-mount bracket guides with
the slider rails installed in the rack.
2
Slide the rack-mount guides onto the slider rails until
the front rack-mount brackets come in contact with
the front rack-mount rails.
b) Align the two rear rack-mount guides on either side of the switch with the slider rails installed in the rack. Slide the
rack-mount guides onto the slider rails, and then gently slide the switch all the way into the rack until the front
rack-mount brackets come in contact with two rack or cabinet posts.
If you attached a grounding cable to the chassis, you will need to bend one of the rack-mount rails slightly
Note
to allow the grounding lug to go behind the rail.
c) Holding the chassis level, insert two screws (12-24 or 10-32, depending on the rack type) in each of the two front
rack-mount brackets (using a total of four screws) and into the cage nuts or threaded holes in the vertical rack-mounting
rails (see the following figure).
Cisco Nexus 93180YC-EX ACI Mode Hardware Installation Guide
20
3
Front-mount brackets.
4
Mounting rails on rack or cabinet posts.
Installing the Switch Chassis
Advertisement
Table of Contents
