Table of Contents
Advertisement
Available languages
Available languages
Notes Regarding Operation
1
All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when
installing your unit.
2
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so
after being turned off.
3
All fog machines have a recycling period after long bursts when the machine will shut itself down for a
short period in order to heat up again. During this time no fog can be produced.
4
If you experience low output, pump noise or no output at all, disconnect from mains immediately. Check
the fluid level, the external fuse, remote control connection and the power supply. If all of the above
appears to be ok, reconnect the unit again. If fog does not come out after holding the MANUAL button
on the remote control for 30 seconds, check the tube attached to the tank to make sure there is fluid
going through it. If you are unable to determine the cause of the problem, do not simply continue
pushing the remote button, as this may damage the unit. Return the machine to your dealer.
..............................................................................................................................................................................
8
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the unit, in particular the output nozzle. Please use a soft lint-free and
moistened cloth for the outside of the unit. Never use alcohol or solvents!
Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container and
the fog machine liquid tank immediately after filling.
Cleaning the Heating Element
The heating element should regularly be cleaned every 40 operational hours in order to avoid clogging. Use
fog machine cleaner available at your dealer.
All fog machines are prone to clogging due to the thick consistency of fog liquid and the high temperature at
which it vaporizes. However, a properly maintained fog machine should provide years of reliable use.
Procedure:
Fill cleaner into empty tank. Run the machine several times in a well-ventilated room only. The number of
repetitions depends on the pollution level of the vaporizing elements. After use, clean all remaining cleaner
and rinse the tank thoroughly.
The EUROLITE fog fluids we recommend are non-hazardous to the environment and can be disposed of via
the sewage system.
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers. Should you need any spare parts, please use genuine parts. If
the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only in
order to avoid hazards.
If defective, please dispose of the unusable device in accordance with the current legal regulations. Should
you have further questions, please contact your dealer.
www.eurolite.de
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
29
Advertisement
Table of Contents
