Product Layout - LevelOne WAC-2000 User Manual

2.3 Product Layout

2.3.1 Front Panel
AC Controller front panel is like following:
LED indicator
LED Light Name
Power Power Light
Run System Light
Reset button
If you need to restore the AC Controller into factory default, please do following procedure: Power on AC Controller, use a pin
to press and hold the reset button until all LED becomes quick-flash from slow-flash.
Then release the button and wait AC Controller to reboot to its factory default settings. After that, the default IP address of AC
Controller is still 192.168.10.1, default user name and password are both admin;
RJ45 Ports: 5x 10/100M/1000Mbps auto-negotiation RJ45 Ethernet Port;
Support any connection devices in 10/100M/1000Mbps bandwidth;
DC: Connect with 12V/1.5A DC adapter, to power this AC controller. Please use original power cord for installation; Set locate
power outlet near the devices, to make safer and easier installation and operation
Notice:
LAN/WAN port is LAN port only on the default mode, only when WAN setting is enabled then LAN/WAN port will change to
WAN port;
2.3.2 Rear Panel
AC Controller rear panel is blank like following:
P2-1 AC Controller's Front Panel Diagram
Indication
Power is on, means status is up;
Power is off, mean status is down;
flashing, means system status is normal
off or stable steady, means status is abnormal
P2-2 AC Controller Rear Panel Diagram
6