Trango Systems SUNSTREAM WIRELESS M5800SB-SU-EXT Installation And Operating Instructions Manual

5.8 ghz digital spread spectrum wireless internet subscriber unit

Advertisement

Quick Links

MODEL M5800SB-SU-EXT
5.8 GHz Digital Spread Spectrum Wireless Internet Subscriber Unit
Installation and Operating Instructions
SUNSTREAM WIRELESS, A DIVISION OF TRANGO SYSTEMS, INC.
COPYRIGHT 2001

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SUNSTREAM WIRELESS M5800SB-SU-EXT and is the answer not in the manual?

Questions and answers

Summary of Contents for Trango Systems SUNSTREAM WIRELESS M5800SB-SU-EXT

  • Page 1 MODEL M5800SB-SU-EXT 5.8 GHz Digital Spread Spectrum Wireless Internet Subscriber Unit Installation and Operating Instructions SUNSTREAM WIRELESS, A DIVISION OF TRANGO SYSTEMS, INC. COPYRIGHT 2001...
  • Page 2 •Setup transceiver per instructions herein before installing outdoors. •Mount the dish antenna to a wall or earth grounded mast 1.5 to 2.5 inches in diameter. • Install transceiver to dish antenna mounting arm. The pole must be securely mounted so that it does not move, and may be from 1.5”...
  • Page 3: Fcc Information

    hank you for choosing Sunstream Wireless to fulfill your wireless internet access needs. Unpack your system carefully. If any items are missing, notify your sales representative. If an item appears to be damaged from shipment, replace it in its packing material and notify the shipper.
  • Page 4 Any such modifications could void the user’s authority to operate the equipment and will void the manufacturer’s warranty. IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the following antenna installation and device operating configurations must be satisfied – The antenna for this unit must be fixed-mounted on outdoor permanent structures with a separation distance of at least 2 meters from all persons and must not be co-located or operating in conjuction with any other antenna or transmitter.
  • Page 5: System Description

    System Description: The M5800SB-SU-EXT is a broadband wireless internet access system designed for sending and receiving Ethernet based data traffic where conventional wiring is impractical or when higher connection speeds are required. The system utilizes robust spread spectrum technology to reduce susceptibility to interference. The typical subscriber installation consists of an M5800SB-SU-EXT transceiver mounted outdoors with a dish antenna and a junction box mounted indoors.
  • Page 6 • FIGURE 1 • Figure 1 shows installation of the dish and transceiver. • FIGURE 2 • Figure 1 shows installation of the junction box and power adapter. Copyright © 1999 Sunstream Wireless, LLC All rights reserved.
  • Page 7: Hardware Installation

    Installation: Typically the service provider will program the transceiver and professionally install the entire system. If you are installing the system yourself, below you will find a step by step guide. TRANSCEIVER SETUP PRIOR TO INSTALLATION Before installing the hardware you must set up the transceiver to allow communication with the base station.
  • Page 8: Antenna Alignment

    1) Keep the transmission path as open as possible. Objects such as walls and metallic objects near the transmission path reflect signals and may reduce the transmission distance. 2) Do not add additional lengths of cable to connect the to the antenna as significant losses in signal and reduced transmission range will occur.
  • Page 9 M5800SB-SU-EXT Inputs and Outputs 1. POWER INPUT Accepts a 10.5-24 Vdc power source such as the standard 20 Vdc adapter (supplied with Sunstream part number ODU-PKIT-1). 2. ETHERNET DATA INTERFACE Use a shielded cat 5 cable to connect the junction box to the transceiver unit. It is ok to us UTP for the indoor connection to the switch or PC.
  • Page 10 Modulation: 1 MBPS DBPSK for header, 11 MBPS CCK spread spectrum for payload Data Input Section Buffer size: 128K Bytes Data Rate (User): Up to 9.5 MBPS Sustained throughput Format: 10/100 BaseT IEEE 802.3 Ethernet compliant Ethernet packet size: Up to 1760 byte long packets Power Input Voltage: Input voltage range at unit is 10.5 VDC to 24 VDC max...
  • Page 11: Standard Antenna

    Mechanical and Environmental General Material: Powdercoated Aluminum base with polycarbonate radome Size: 12.5”x5”x8” including mounting studs Weight: 4 lb Mounting: Grey steel pole mount provided Connectors/Indicators RF Output: Direct connect to antenna per Part 15C, 15.203. FCC Compliance: The transceiver shall comply with the following: FCC Part 15.247 FCC Part 15.207(a) Serial Interface:...

Table of Contents