Table of Contents
Advertisement
T ) ATX_12V ( +12V Power Connector)
2
1
GND
+12V
4
3
A ) CPU_FAN (CPU FAN Connector)
1
D) SYS_FAN (System FAN Connector)
GND
1
+12V/Control
N C
R ) F_AUDIO (Front Audio)
Rear Audio (L)
Rear Audio (R)
POWER
ØIf you want to use "Front Audio" connector, you must move 5-6, 9-10 Jumper. In order to utilize the
front audio header, your chassis must have front audio connector. Also please make sure the pin
assigment on the cable is the same as the pin assigment on the MB header. To find out if the chassis
you are buying support front audio connector, please contact your dealer.
Ø This connector (ATX +12V) suppliesthe CPU
operation voltage (Vcore).
GND
+12V
If this " ATX+ 12V connector" is not connected,
system cannot boot.
Ø
Please note, a proper installation of the CPU
cooler is essential to prevent the CPU from
running under abnormal condition or damaged
by overheating.The CPU fan connector
supports Max. current up to 600 mA.
P ) CI (CASE_OPEN)
Ø This 2 pin connector allows your system to
enable or disable the system alarm if the
system case begin remove.
10
9
GND
2
1
- 17 -
1
Front Audio (L)
Reserved
Front Audio (R)
REF
MIC
Hardware Installation Process
Advertisement
Table of Contents
