Table of Contents
Advertisement
On the Fathom IWSv2's Front Panel:
Please turn off the home theater receiver or preamp/processor to make
these adjustments.
1. "Power" Switch
Flip each Fathom IWSv2's "Power" switch to the "On" position.
2. "Lights" Switch
Flip each Fathom IWSv2's "Lights" switch to the "On" position. If you don't
see any lights on the front panel, you may have forgotten to plug the Fathom
IWSv2 in or there may be a problem with the electrical circuit.
3. "Input Mode" Indicator Lights
If you are using a single Fathom IWSv2, confirm that its "Input Mode"
indicator light is on the "Master" position. If not, you will need to access the
"Input Mode" switch on the rear panel of the Fathom IWSv2.
If you are using multiple Fathom IWSv2s in a Master/Slave configuration,
confirm that the unit connected directly to your receiver or preamp/processor
is indicating "Master" on its "Input Mode" lights and that all other units are
indicating "Slave" on their "Input Mode" lights. If not, you will need to access
the "Input Mode" switches on the rear panels of the Fathom IWSv2s.
3. "Level Mode" Switch
Flip the master Fathom IWSv2's "Level Mode" switch to the "REF" position.
4. "LP Filter" Switch
If your home theater receiver/processor is handling bass management
(speakers set on "small") or if you are using an outboard crossover/bass-
management processor, flip the master Fathom IWSv2's "LP Filter" switch to
"OFF." If not, select the "12 dB" position.
5. "LP Freq. (Hz)" Knob
Rotate the "LP Freq." knob to the "80 Hz" position.
6. "e.l.f. trim (dB)" Knob
Rotate the "e.l.f. trim" knob to "0"
7. "Polarity" Switch
Flip the "Polarity" switch to "0".
8. "phase (deg.)" Knob
Rotate the "phase" knob to "0" degrees
9. D.A.R.O. Defeat Switch
Press the D.A.R.O. defeat switch so that the red light in the
switch remains lit.
Page 28
| Fathom IWSv2
Advertisement
Table of Contents
