JL Audio Fathom IWSv2-SYS-113 Owner's Manual page 23

SYSTEM CONNECTION DIAGRAM 1:
One Fathom IWSv2 to
Home Theater Receiver or
Home Theater Preamp/Processor
Most home theater receivers and
preamp/processors provide a single
(mono) subwoofer output. When
connecting a mono subwoofer output
to your Fathom IWSv2, you will only use
the Fathom IWSv2's "Left or Mono" input.
Two connection types are available
for connecting the Fathom IWSv2 to your
home theater system: balanced (XLR or
1/4-inch TRS connector) and unbalanced
(RCA-type connector). Balanced
connections provide superior noise
rejection and ensure proper grounding
between components. If your receiver
or processor has balanced outputs, we
highly recommend that you use them.
In the connection diagram at left,
balanced connections are shown as solid
lines, unbalanced connections are shown
dotted. You will only use one of these
input connection methods (not both).
WARNING
| Fathom IWSv2
PROCESSOR (BALANCED OUTPUTS)
OUTPUTS
WARNING! TURN OFF THE FATHOM IWSv2 AND ALL OTHER EQUIPMENT
IN THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
RECEIVER / PROCESSOR (UNBALANCED OUTPUTS)
FRONT
OR
FRONT
FATHOM REAR CONTROLS (MASTER)
PRE OUT
REAR CENTER
L
R REAR SUB
Page 23