Table of Contents
Advertisement
Parts and their functions
LAN connector for IP control [LINK/ACT]
i
This LAN connector (RJ-45) is connected when exercising
IP control over the unit from an external device.
Use a cable with the following specifications for the
connection to the LAN connector:
When connecting through a hub:
LAN cable* (category 5 or above),
max. 100 meters [328 ft]
When using a PoE+ compatible hub:
LAN cable* (category 5e or above),
max. 100 meters [328 ft]
When a hub is not used:
LAN cable* (category 5 or above),
max. 100 meters [328 ft]
*: Use of an STP (shielded twisted pair) cable is
recommended.
Anti-theft wire mounting hole
j
Use this hole to attach the wire bracket (commercially
available).
Audio input connector [AUDIO IN]
k
Inputs external audio (microphone, line).
RS-232C connectors [RS-232C IN/OUT]
l
Connect to RS-232C cables.
RS-232C IN/OUT
RS-232C IN
connector
Pin
No.
1
1
2
2
3
4
5
3
7
4
6
8
5
● Mini DIN 8-pin
6
(JST)
7
8
Note
● Be aware that the polarities (+/−) of the serial data
may be different depending on the specifications of
the device to be connected.
DC IN connector [12V
m
Connect the AC adaptor supplied with the unit to this
connector to supply the DC 12 V voltage to the unit.
Cable clamp
n
This is used to hold the cable connection to the DC IN
connector and prevent it from becoming disconnected.
Ground connector
o
Connects to the ground connector on a wall outlet, ground
bar, etc. for grounding. (page 25)
(continued)
RS-232C OUT
Pin
Signal
Signal
No.
DTR_IN
1
DTR_OUT
DSR_IN
2
DSR_OUT
TXD_IN
3
TXD_OUT
GND
4
GND
RXD_IN
5
RXD_OUT
GND
6
GND
IR OUT R
7
NC
IR OUT L
8
NC
IN
]
RS-422 connector [RS-422]
p
This RS-422 connector (RJ-45) is connected when
exercising serial control over the unit from an external
device.
Use a cable with the following specifications for the
connection to this connector.
The tally lamp can be lit by shorting the TALLY signal (pin
2) with GND (pin 1).
Note
● Do not apply a voltage to the TALLY signal pin.
LAN cable* (category 5 or above, straight cable), max.
1000 meters [3280 ft]
*: Use of an STP (shielded twisted pair) cable is
recommended.
Pin
1 3 5 7
2 4 6 8
No.
1
2
3
4
USB port
q
The unit can be used as a Web camera by connecting the
unit and a personal computer with USB Video Class.
microSD card slot
r
The video and audio of the camera can be recorded to a
microSD card in MP4 format.
Threaded hole (thread: 1/4-20UNC, ISO1222
s
[6.35 mm]) for mounting the camera
Use this hole when mounting the camera on a tripod, etc.
HDMI connector [HDMI]
t
This is the HDMI video signal output connector.
Pin
Signal
Signal
No.
GND
5
TXD +
TALLY
6
RXD +
RXD –
7
—
TXD –
8
—
41
Advertisement
Table of Contents
