Table of Contents
Advertisement
FFloppy 3 Mode Support (for J apan Area)
8Disabled
8Drive A
8Drive B
8Both
FHalt on
The category determines whether the computer will stop if an error is detected during power up.
8NO Errors
8All Errors
8All, But Keyboar
8All, But Diskette
8All, But Disk/Key
Memory
The category is display-only which is determined by POST (Power On Self Test) of the BIOS.
Base Memory
The POST of the BIOS will determine the amount of base (or conventional) memory
installed in the system.
The value of the base memory is typically 512 K for systems with 512 K memory
installed on the motherboard, or 640 K for systems with 640 K or more memory
installed on the motherboard.
Extended Memory
The BIOS determines how much extended memory is present during the POST.
This is the amount of memory located above 1 MB in the CPU's memory
address map.
KT400A Series Motherboard
Normal Floppy Drive. (Default value)
Enabled 3 mode function of Drive A.
Enabled 3 mode function of Drive B.
Drive A & B are 3 mode Floppy Drives.
The system boot will not stop for any error that may be detected
and you will be prompted.
Whenever the BIOS detects a non-fatal error the system will be
stopped.
The system boot will not stop for a keyboard error; it will stop for
all other errors. (Default value)
The system boot will not stop for a disk error; it will stop for all
other errors.
The system boot will not stop for a keyboard or disk error; it will
stop for all other errors.
- 40 -
Advertisement
Table of Contents
