Init Display First - Gigabyte GA-7N400 User Manual

SATA/RAID/SCSI Boot Order
This function will available when Boot up device set at "SCSI".
This feature allows you to select the boot order Serial ATA, RAID or SCSI device.
SCSI
RAID
SATA
Boot Up Floppy Seek
During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360K type is
40 tracks 720K, 1.2M and 1.44M are all 80 tracks.
Enabled
Disabled
Flexible AGP 8X
Auto
4X

Init Display First

This feature allows you to select the first initiation of the monitor display from which card when you
install an AGP card and a PCI VGA card on board.
PCI
AGP
N400 Pro2 / N400 Series Motherboard
7n400pro2_1001_b.p65
Select your boot device priority by PCI SCSI.
Select your boot device priority by RAID.
Select your boot device priority by Serial ATA.
BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Note
that BIOS can not tell from 720K, 1.2M or 1.44M drive type as they are all
80tracks.
BIOS will not search for the type of floppy disk drive by track number. Note
that there will not be any warning message if the drive installed is 360K.
(Default value)
Automatically set AGP transfer rate according to AGP compatibility and
stability. (Default value)
Set AGP transfer rate to 4X mode no matter what the AGP transfer rate the
card is.
Set initial display first to PCI slot. (Default value)
Set initial display first to AGP.
- 46 -
46 2003/7/4, ¤U¤È 03:29