Sony DRN-XM01H2 Service Manual page 11

4-2. DIAGNOSTIC MODE
4-2-1. SETTING THE DIAGNOSTIC MODE
Press the JOG roller and the preset button 5 simultaneously for
three seconds under the condition of power-off.
Press the JOG roller when the set is powered on.
4-2-2. EXITING THE DIAGNOSTIC MODE
Press the POWER button to exit from this mode.
4-2-3. MENU
Select the menu and press the JOG roller.
JOG roller
MENU
DIAG. MODE
MENU
MENU
SCROLL MODE
MENU
RECEPTION
4-2-4. OPERATION
[Diagnostic Mode]
Procedure:
1. Select the MENU DIAG. MODE and press the JOG roller.
2. The message "STATE1 QOS Test" is displayed.
3. Select the message(menu) by rotating the JOG roller up or down
as following order.
STATE1
STATE2
STATE3
STATE4
STATE5
Down
STATE6
STATE7
STATE8
STATE9
4. Press the DSPL/BACK/BAND button to return the DIAG.
MENU.
BER
STATUS
QOS Test
Terr Err
Sat1 Err
Sat2 Err
Tuner Stat
Up
Audio Err
Gen Err
Ext Err0
Ext Err1
DRN-XM01C2/XM01CK2/XM01H2/
[BER Display Mode]
Procedure:
1. Select the MENU BER and press the JOG roller.
2. The following message is displayed.
XXX1 XXX2 XXX3 E
MENU
XXX4 XXX5 X6 X7
3. Press the DSPL/BACK/BAND button to return the DIAG.
MENU.
4-3. SYSTEM ERROR LIST
If system error is happened, the message of system error is displayed
and the set sounds beep.
SYSTEM ERROR
XXXXXXXXXXXXXXXXXXXX
INFORMATION OF ERROR
(XXXXXXXXXXXXXXXXXXXX)
TUNER UNLOCKED
DSP NO RESPOND
DSP INCORRECT RESP.
UNSUPPORTED DSPSW
CDEC NO RESPOND
I2C BUS ERROR
CAP ERROR
EEPROM ERROR
EEPROM FORMAT ERROR
XM01HK2/XM01R2
XXX1 : SAT1 BER
(4 digits Hex data)
XXX2 : SAT2 BER
(4 digits Hex data)
XXX3 : TERR BER
(4 digits Hex data)
XXX4 : RS Error Byte
(4 digits Hex data)
XXX5 : RS Error Block
(4 digits Hex data)
X6 : SAT AGC
(2 digits Hex data)
X7 : TER AGC
(2 digits Hex data)
E : Ensemble
(A, B or space)
xx xx : Error information per bit
11