Jp4: Usb Device Wake Up Selection - Gigabyte GA-6VMML User Manual

JP4: USB Device Wake up Selection

Please Note: (If you want to use " USB KB Wake up from S4~S5 " function, you have
to set the BIOS setting "USB KB Wake up from S4~S5" enabled, and the jumper " JP4
& JP9 " enabled).
*(Power on the computer and as soon as memory counting starts, press <Del>. You
will enter BIOS Setup. Select the item "POWER MANAGEMENT SETUP", then select
"USB KB Wake up from S4~S5". Remember to save the setting by pressing "ESC" and
choose the "SAVE & EXIT SETUP" option.)
JP5/JP6/JP7 : Onboard AC97& AMR (Primary or Secondary ) Select
(AMR Audio Modem Riser) (Optional)
Please note:
JP7: 1-2 close: If you use software audio(onboard CODEC only), your modem riser
must be "Secondary". JP7: 2-3 close: If you don't use onboard software audio, your
audio/modem riser must be "Primary". Mainboard's software audio will be disabled.
There are two types of AMR/MR card in the market, Primary and secondary. If your
AMR/MR card is primary, JP7 should be set to 2-3, if you have secondary AMR/MR
card JP7 should be set to 1-2. Warning! If Primary AMR/RM card is used, on-board
audio will be disabled.
1
Normal
(Default)
Pin No.
1-2 close Normal (Default)
2-3 close USB Wake Up
1
1 JP6
1 JP5
Jumper
JP5
Function
Only AC97
1-2
(Default)
Only AMR
3-4
(Primary)
AC97+MR 1-2
(Secondary) 3-4
32
Panel and Jumper Definition
1
Enable
Definition
JP7
JP6 JP7
1-2 1-2
3-4 2-3
1-2 1-2