Protecting The Environment; Maintenance - DeWalt DW872 Original Instructions Manual

1. Place the material to be cut against the fence
towards the operator as possible. Secure using the material
6
clamp .
2. Switch on the machine and pull down the main handle
to cut the workpiece. Allow the motor to reach full speed
before cutting.
3. Allow the blade to cut freely. Do not force.
4. After completing the cut, switch off the machine and return
the arm to its upper rest position.
Switching On and Off (Fig. A)
1
The on/off switch is mounted in the main handle
To run the tool, press the on/off switch
Keep the on/off switch depressed while performing
the operation.
To stop the tool, release the switch.

WARNING: Do not switch the tool on or off when
under load.

WARNING: Do not cut magnesium.
Transporting (Fig. F)
The tool is equipped with a lock-down pin
tool in closed-down position for carrying.
4
1. Lower the guard onto the cutting table
tool in this position by pushing in the lock-down pin
2. Transport the tool using the carrying handle
3. To release the tool, pull out the lock-down pin
Proper Hand Position (Fig. A, G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
and the other hand holding the workpiece away from the blade.

WARNING:
• Never place your hands near the cutting area.
• Hold the workpiece tightly to the table and the fence
when cutting. Keep your hands in position until
the switch has been released and the blade has
completely stopped.
• Do not cross your hands.
• Keep both feet firmly on the floor and maintain
proper balance.

MAINTENANCE

Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
7
and as far
2
2
.
1
.
21
which locks the
9
and secure the
21
.
3
.
21
.
2
installing attachments or accessories. An accidental
start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
EngLIsh
WALT recommended
e
33